Status area and status displays

The status area is located on the left side above the main menu area . (See also “Home screen” figure and table).

If a status is active, it is possible to display and select status menu items in the main menu.
Turn the control knob to the status area to show the active status.
If an active process (e.g. venting process) is quit or discarded, the status display is hidden again.

Main menu status display

There are three different classes of status displays:

Display process:
On-going processes have been highlighted in blue.
Processes mean pump operation may deviate from the adjusted control.
Example: Venting process.
Display warning:
Warning messages have been highlighted in yellow.
The pump functions are restricted if a warning has been output. (See the “Warning messages” section).
Example: Cable break detection on analogue input.
Display error:
Error messages have been highlighted in red.
The pump stops operation if an error has occurred. (See section “Error messages”).
Example: Ambient temperature too high.

Example of a process display. Here: “Venting”

Status display venting

The “Venting” icon has been selected in the main menu. The venting process is active and information about venting is displayed.

Further status displays can be displayed, if they are available, by turning the control knob to the corresponding symbol.

Potential data displayed in the status area
Symbol	Meaning
	Error message Pump stopped!
	Warning message Pump operation restricted!
	Active venting Venting in progress. Subsequently returns to normal operation.
	Communication status – a CIF module has been installed and is active. Pump in control mode, monitoring and control by building automation available.
	Software update started – transfer and verification Pump continues to run in control mode until the update bundle has been fully transferred and verified.

Additional settings can be made in the context menu. For this purpose, press the Context button .
Press the Back button to return to the main menu.

You can already make additional settings at the pump during the venting process. These settings become active when the venting process is completed.

NOTICE

Any set control mode is interrupted while a process is running. After completing the process, the pump continues to run in the set control mode.

NOTICE

Behaviour of the back button in case of an error message of the pump.

Repeatedly pressing or pressing and holding the Back button after an error message has occurred will open the “Error” status display and not take you back to the main menu.
The status area is highlighted in red.