Repairs

WARNING

warning

Risk of injury from sharp edges!

Sharp edges can form on the propeller blades. There is a danger of cuts and similar injuries!

  1. Wear protective gloves!

The following preconditions must be met prior to starting repair work:

  • Wear protective equipment! Observe the work regulations.
    • Safety shoes: Protection class S1 (uvex 1 sport S1)
    • Protective gloves: 4X42C (uvex C500)
    • Safety goggles: uvex skyguard NT
  • For detailed marking of frame and disc, see the section on “Personal protective equipment”.
  • The mixer has been thoroughly cleaned and disinfected.
  • Motor must have cooled down to the ambient temperature.
  • Workplace:
    • Clean, good lighting and ventilation.
    • Firm and stable work surface.
    • Secured against falling over and slipping.

CAUTION! Do not set the mixer down on the propeller! Provide an appropriate platform.

NOTICE! Only carry out the repair work described in these installation and operating instructions.

For repair work, the following applies:

  • Wipe up spillage quantities of fluid and operating fluid immediately!
  • Always replace O-rings, gaskets and screw locking devices!
  • Observe the tightening torques in the appendix!
  • The use of force is strictly prohibited!