During operation

Make sure the following points are observed during operation:

Keep the switchgear closed and secure it against unauthorised opening.
Switchgear attached in an overflow-proof manner (protection class IP54).
Not exposed to direct sunlight.
Ambient temperature: -30 … +50 °C.

The following items of information are shown on the main screen:

Pump status:

Number of registered pumps
Pump activated/deactivated
Pump On/Off

Operation with standby pump
Operating mode: fill or drain
Current water level or switching state of the float switch
Active field bus operation

Furthermore, the following information is available via menu 4:

Press the operating button for 3 s.
Menu 1.00 appears.
Turn the operating button until menu 4 appears.
Press the operating button.

Menu 4.xx appears.

	Current water level in m
	Current switching state of the float switch
	Switchgear running time The time* is stated depending on the unit, in minutes (min), hours (h) or days (d).
	Running time: Pump 1 The time is stated in minutes (min), hours (h) or days (d) depending on the unit. The display varies depending on the timespan: 1 hour: Display in 0 … 59, unit: min 2 hours to 24 hours: Display in hours and minutes separated by a decimal point, e.g. 10.59, unit: h 2 days to 999 days: Display in days and hours separated by a decimal point, e.g. 123.7, unit: d From 1000 days: Display in days, unit: d
	Running time: Pump 2 The time is stated in minutes (min), hours (h) or days (d) depending on the unit.
	Running time: Pump 3 The time is stated in minutes (min), hours (h) or days (d) depending on the unit.
	Switchgear switching cycles
	Switching cycles: Pump 1
	Switching cycles: Pump 2
	Switching cycles: Pump 3
	Serial number Display switches between the 1st and 2nd four digits.
	Switchgear type
	Software version
	Set value for the motor current monitoring: Pump 1 Max. Rated current in A
	Set value for the motor current monitoring: Pump 2 Max. Rated current in A
	Set value for the motor current monitoring: Pump 3 Max. Rated current in A
	Current rated current of pump 1 in A display changes between L1, L2 and L3 press and hold the operating button. The pump starts after 2 s of pumping operation until the operating button is released.
	Current rated current in A for pump 2 display changes between L1, L2 and L3 press and hold the operating button. The pump starts after 2 s of pumping operation until the operating button is released.
	Current rated current in A for pump 3 display changes between L1, L2 and L3 press and hold the operating button. The pump starts after 2 s of pumping operation until the operating button is released.