Cleaning and disinfection

  1. The pump chamber is decommissioned.
  1. Remove the chamber cover.
  2. Activate the pumping station:
  3. Pumping station without a switchgear: Put the plug into the socket.
  4. Pumping station with a switchgear: Activate the switchgear at the main switch. Set the automatic mode.
  5. Open the shut-off valve in the discharge pipe.
  6. Flush the discharge pipe with the flush connection attached. Disconnect the flush connection.
  7. Flush the inside of the pump chamber with clean water from top to bottom through the chamber opening.
  8. Disinfect the pump chamber.
  9. Drain the pump chamber.
  10. Do more steps 5 to 7 until the pump chamber, pump and level control device are cleaned.
  11. Close the shut-off valve in the discharge pipe.
  12. Pump out the leftover fluid through emergency draining.
  13. Decommission the pumping station.
  14. Let the pumping station dry out.
  15. Fit the chamber cover.
  1. The pump chamber is cleaned and disinfected. Each component can now be removed.