Installing the flush connection

1

Surface coupling

2

Gate valve

3

Flush connection (1")

4

Flush connection extension (L = 300 mm)

5

Flush connection (L = 300 mm)

6

Flush connection cover (dummy coupling Storz C-52)

  1. The flush connection is installed directly on the surface coupling.
  2. The inlet is connected using a Storz coupling C-52.
  1. Remove the sealing plug on the 1" connection on the surface coupling.
  2. Apply a standard sealant (hemp, Teflon tape) around the thread on the flush connection.
  3. Screw the flush connection into the connection on the surface coupling.
  4. Remove the dummy coupling on the flush connection and connect the inlet.
    If the flush connection is positioned too low, it can be adjusted using an extension. A dedicated number of extensions can be screwed together depending on the required height.
    CAUTION! Make sure to seal each thread connection using a standard sealant (hemp, Teflon tape).
Flush connection installation
Flush connection installation