Installation
WARNING
Risk of injury without protective equipment!
During work, there is a risk of (serious) injury to feet and hands.
- Wear safety gloves.
- Wear safety shoes.
DANGER
Danger through lone working!
Working in chambers, narrow rooms, and in areas with a risk of falling can be dangerous. Do not work alone.
- Only do this work with a second person.
WARNING
Risk of injury without protective equipment!
During work, there is a risk of (serious) head injury.
- Wear safety helmet (if a lifting equipment is used).
NOTICE
Installation of the pump chamber outside the building in the ground
Obey EN 1610 and local regulations.
- Make sure that the operating space is sufficiently ventilated.
- Make sure that all connection cables are laid correctly. Prevent the connection cables from causing any risk (i.e. tripping, damage during operation). Examine if the cable cross-section and the cable length are sufficient for the selected installation type.
- Toxic or asphyxiating gases can collect during work.
- If toxic or asphyxiating gases collect, go out of the workplace immediately.
- Install lifting accessory on a flat, clean and hard surface. Make sure to access the storage area and installation location easily.
- Attach the chain or wire rope to the slinging points with a shackle. Only use technically approved lifting slings.
- If it is no longer safe to work because of the weather conditions (e.g. ice formation, strong wind), stop work immediately.
Additional information
- Work steps
- Preparing the installation
- Excavating the pit
- Installing the pump chamber
- Filling the pit 1/3 to fix the pump chamber
- Preparing pipe connections
- Installing the pump chamber extension
- Filling the pit
- Installing the pump
- Installing the level control device
- Laying the connection cables
- Installing the pump chamber cover
- Installing the flush connection and vacuum relief valve