Storage

DANGER

Danger through bacterial infection!

The pump chamber is used for collecting and pumping sewage. There can be bacteria and hazardous germs. Follow these points:

1. After removal, disinfect the pump chamber.
2. Obey the factory regulations.

• Fully drain the pump chamber.
• Put the pump chamber upright on a flat surface. Make sure that the product is stable.
• Prevent the pump chamber from slipping and falling over.
• Permitted storage temperature:
• Maximum: -15 ... +60 °C (5 ... 140 °F), max. humidity: 90 %, non-condensing.
• Recommended: 5 ... 25 °C (41 ... 77 °F), relative humidity: 40 ... 50 %.
• Seal all open connections in a watertight manner.
• Do not keep the pump chamber in spaces where welding work is carried out. The caused gases or radiation can corrode the pump chamber.
• Keep the pump chamber out of direct sunlight, heat and frost. Very high heat and frost can damage the pump chamber.
• If pumps or signal transmitters are installed in the pump chamber, follow these points:
• Wind up the connection cables. Keep the bend constant. Attach the cables in the pump chamber.
• Seal open ends of the connection cables in a watertight manner. Do not immerse the open cable end in the fluid.
• Obey the manufacturer's instructions for the storage of the pumps and signal transmitters.
• Obey the manufacturer's instructions for the storage of the switchgear.