Clogged hydraulics cleaning (only Drain LPC 50 and LPC 80)
WARNING
Risk of burns from hot surfaces and fluids!
The pipework, the pump housing, and the fluid can heat up to 80 °C (176 °F). There is a risk of skin burns if components are touched.
- Mark and close the working area.
- Keep not permitted persons away from the working area.
- Cool down the pump to ambient temperature after switching off.
7 | Cover of the inspection opening |
8 | Cover fixation |
- Wear protective equipment. Obey the factory regulations.
- Make sure that the pump is shut down.
- Prevent the pump from unapproved start-up.
- Make sure that the pump has cooled to ambient temperature.
- Close the gate valves in the suction pipe and discharge pipe.
- Unscrew the two screws on the inspection opening.
- Remove the cover from the inspection opening. The fluid drains out.
- Remove the insert from the inspection opening.
- Remove dirt and blockages from the hydraulics.
- Clean the inspection opening, insert, cover, and the seal.
- Install the insert in the inspection opening.
- Install the cover and seal against the inspection opening.
- Fasten the cover with the two screws.
