Installation of switchgear

Attach the switchgear to the wall with four screws and wall plugs:

  1. The switchgear is disconnected from the mains supply and is voltage-free (battery unplugged).
  2. There is a socket available within a radius of 1 m around the switchgear.
  1. Mark the boreholes at the installation site. Refer to the dimensional specifications on the housing bottom.
  2. Drill and clean the mounting holes in accordance with the specifications of the fixation material.
  3. Loosen the screws at the cover and remove the cover.
  4. Attach the lower part to the wall with the fixation material.
    Check the lower part for deformations! Realign deformed housing (e.g. by placing alignment plates below it) to ensure the housing cover closes securely. NOTICE! If the cover does not close correctly, the protection class is compromised!
  5. Put the cover back on and secure it.
  1. Switchgear installed. Next steps: Connect the power supply and signal transmitter.