Activating the device
NOTICE
Observe the error code on the display
If the red fault LED lights up or flashes, observe the error code on the display! If the error has been confirmed, the previous error will be stored in menu 6.02.
- Switchgear is closed.
- Installation has been performed correctly.
- All signal transmitters and consumers are connected and installed in the operating space.
- If dry-running protection is present, switching point set correctly.
- Motor protection is preset according to the pump data.
- Turn the main switch to the “ON” position.
- Switchgear starts.
– All LEDs light up for 2 s.
– The display illuminates and the start screen appears.
– The standby symbol appears in the display.
- The switchgear is ready for operation. Start the initial configuration or automatic mode.
1 | Current pump status |
2 | Standby pump function activated |
3 | Control mode (e.g. p-c) |
4 | Switching status of float switches/electrodes |
5 | Switching status of float switches/electrodes |
6 | Fieldbus active |
1 | Current pump status |
2 | Standby pump function activated |
3 | Control mode (e.g. p-c) |
4 | Actual pressure value |
6 | Fieldbus active |
