Installation of switchgear

Screw sizes for plastic housing

Installation

Attach the switchgear to the wall with four screws and wall plugs:

  1. Switchgear is disconnected from the mains supply and is voltage-free.
  1. Loosen the screws on the cover and open the cover/switch cabinet door from the side.
  2. Align the switchgear on the installation site and mark the position for the drill holes.
  3. Drill and clean the mounting holes in accordance with the specifications of the fixation material.
  4. Attach the lower part to the wall with the fixation material.
    Check the lower part for deformations! Realign deformed housing (e.g. by placing alignment plates below it) to ensure the housing cover closes securely. NOTICE! If the cover does not close correctly, the protection class is compromised!
  5. Close the cover/switch cabinet door and fasten it with the screws.
  1. Switchgear installed. Now connect the mains supply, pumps and signal transmitter.