Setting “Volume flow Q-c” in the basic control modes

Starting situation

Pump starts in factory settings DA+.

The following operating steps can be set via the menu using the control knob:

→	Settings (turn control knob right + press)

→

Set control mode (press control knob)

→

Setting assistant (press control knob)

→

Basic control modes (press control knob)

→

Volume flow Q-c (turn control knob right + press)

The setting returns to “Setting assistant”. To set a setpoint, press and hold the back button (left). The setting returns to the start screen.

	→	Setpoint volume flow (press control knob)
		Turn to adjust the volume flow setpoint in increments of 0.1 Press the control knob to confirm the volume flow setpoint

NOTICE

The set control mode is shown at the top of the display.
The actual duty point and the measured values are shown on the right-hand side of the display.