Mounting the cover cap

1

Hub

2

Groove for O-ring

3

Tie rod

4

Installation aid (steel rod, 2 pcs, 9 x 250 mm)

5

Cover cap

6

O-ring

  1. Propeller blades attached.
  2. Installation aid is to hand.
  3. Lubricant is to hand.
  1. Cover the interior of the hub with water-resistant grease.
  2. Lightly coat the O-ring with lubricant.
  3. Place the O-ring in the groove.
  4. Screw the short threaded side of the tie rod completely into the drilled hole in the mixer shaft until hand-tight.
  5. Screw the cover cap onto the tie rod until hand-tight. CAUTION! If the O-ring is not completely in the groove, the O-ring will be squeezed and the cover cap will not be sealed!
  6. Insert the installation aid into the holes on the cover cap and screw tight.
  7. Remove steel rods and retain for future dismantling.
  8. Check that the cover cap is firmly secured.
  1. Cover cap is installed. Make the electrical connection.
Installing the cover cap
Installing the cover cap