Installation – ground installation (under ground)
DANGER
Danger due to fluids hazardous to health during installation!
Danger of bacterial infection!
- Clean and disinfect installation location.
- Wipe up drips immediately.
- Observe the specifications of the factory regulations!
- If contact with fluids that are hazardous to health is possible, wear the following protective equipment:
- sealed safety glasses
- mouth protection
- safety gloves
DANGER
Risk of fatal injury due to dangerous lone working practices!
Work in chambers and narrow rooms as well as work involving risk of falling are dangerous work. Such work may not be carried out autonomously!
- Only carry out work with another person!
WARNING
Suspended loads!
Danger of (serious) injuries caused by falling parts.
- Standing under suspended loads is prohibited!
- Do not move loads over workplaces where persons are present!
CAUTION
Buoyancy due to high ground water level!
Elevated groundwater can cause the pump chamber to float up.
- Observe information on the maximum permissible groundwater level.
CAUTION
Malfunction due to frost!
Frost can cause malfunctions and damage.
- Pay attention to local frost depths.
- If the unit or discharge outlet are in the freezing zone, take the unit out of operation during freezing periods.
NOTICE
Installation of the pump chamber outside buildings
Observe EN 1610 and local regulations during ground installation!
- Wear protective equipment! Observe the work regulations.
- Protective gloves: 4X42C (uvex C500 wet)
- Safety shoes: Protection class S1 (uvex 1 sport S1)
- Safety helmet: EN 397 Conforms to standards, protection against lateral deformation (uvex pheos)
- (When using lifting equipment)
- Pay attention to local frost depths.
- If toxic or asphyxiating gases accumulate, leave the workplace immediately!
- Install lifting equipment: even surface, clean, firm base. Warehouse and installation location must be easily accessible.
- Attach the chain or wire rope to the attachment points with a shackle. Only use lifting gear that has been technically approved.
- Do not stay within the swivel range of the hoisting gear.
- Provide threading strip for the installation of the connection cables.
- Installation of switchgear: Observe information in the manufacturer’s instructions (IP class, overflow-proof, potentially explosive atmospheres)!