Installation – building installation (above ground)
DANGER
Danger due to fluids hazardous to health during installation!
Danger of bacterial infection!
- Clean and disinfect installation location.
- Wipe up drips immediately.
- Observe the specifications of the factory regulations!
- If contact with fluids that are hazardous to health is possible, wear the following protective equipment:
- sealed safety glasses
- mouth protection
- safety gloves
DANGER
Risk of fatal injury due to dangerous lone working practices!
Work in chambers and narrow rooms as well as work involving risk of falling are dangerous work. Such work may not be carried out autonomously!
- Only carry out work with another person!
NOTICE
Installation of the pump chamber inside buildings
Observe EN 12056 and local regulations during installation!
- Wear protective equipment! Observe the work regulations.
- Protective gloves: 4X42C (uvex C500 wet)
- Safety shoes: Protection class S1 (uvex 1 sport S1)
- Prepare the installation site:
- Clean, free of coarse solids
- Dry
- Frost-free
- Well lit
- Ensure operating space has sufficient ventilation.
- If toxic or asphyxiating gases accumulate, leave the workplace immediately!
- Ensure a clearance area of min. 60 cm (2 ft) around the unit.
- In the event of an accident: Provide pump sump in the operating space, min. dimensions: 500x500x500 mm (20x20x20 in). Select pump accordingly. Ensure that manual drainage is possible.
- All connection cables must be laid properly. The connection cables must not pose any risk (i.e. tripping, damage during operation). Check whether the cable cross-section and the cable length are sufficient for the selected installation type.
- The mounted switchgear is not overflow-proof. Install the switchgear at an adequate height. Ensure good operation!