Settings menu

In the “Double pump operation” menu, a double pump connection can be established or disconnected and also the double pump function can be adjusted.

In the “Settings” menu , select

  1. Double pump operation.
Menu double pump operation

Menu “Double pump function”

When a double pump connection is established, the “Double pump function” menu is used to switch between

  • Main/standby operation and
  • Efficiency-optimised peak-load operation (parallel operation)
  • .

NOTICE

When switching the double pump function, different parameters of the pump are fundamentally changed. The pump is then started automatically.

Menu “Pump cycling interval”

If a double pump connection is established, the time interval can be set in the “Pump cycling interval” menu. Time interval: between half hour and 24 hours.

Menu “Connecting double pump”

If double pump connection is not yet established, in the “Settings” menu , select

  1. “Double pump operation”
  2. “Connecting double pump”.

When the Wilo Net connection is established (see “Wilo Net” section), a list of available and appropriate double pump partners will appear under “Connecting double pump”.
Appropriate double pump partners are pumps of the same type.

When the double pump partner is selected, the display of this double pump partner is switched on (Focus mode). In addition, the blue LED will flash to identify the pump.

NOTICE

Different parameters of the pump are fundamentally changed when creating the double pump function. The pump is then started automatically.

Menu “Disconnect double pump”

When a double pump function is established, it can also be separated. Select “Disconnect double pump” in the menu.

NOTICE

When separating double pump function, different parameters of the pump are fundamentally changed. The pump is then started automatically.

Menu “Types of DP housing”

The selection of the hydraulic position at which the motor head is installed takes place independent of a double pump connection.

The following selection is available in the “Types of DP housing” menu:

  • Single pump hydraulic
  • Double pump hydraulic I (left, with upward flow direction)
  • Double pump hydraulic II (right, with upward flow direction)

With an existing double pump connection, the second motor head automatically accepts the complementary setting.

  • When the variant “Double pump hydraulic I” is selected, the other motor head automatically adjusts to “Double pump hydraulic II”.
  • When the variant “Single pump hydraulic” is selected, the other motor head automatically adjusts to “Single pump hydraulic”.