Portable wet well installation

The pump can be installed at any location on the application site when carrying out portable wet well installation. Observe and adhere to the following points:

  • Secure the pump against falling over and moving (creeping) during use.
  • Secure the pressure hose to the hose connection.
  1. Site is prepared
  2. Pressure hose to be used: Min. inside diameter 1½"
  3. Hose clip to be used: 40 − 60 mm inside diameter (1.6 − 2.4 in)
  4. Hose connection to be used: G 1½" (with male thread)
  1. Attach the hose connection.
    Twist the hose connection into the pressure port as far as it will go.
  2. Slide the hose clip over the pressure hose.
  3. Slide the pressure hose onto the hose connection at the pressure port.
  4. Secure the pressure hose to the hose connection using the hose clip.
  5. Position the pump at the installation site.
    CAUTION! Use a hard surface or underlay at the installation site to prevent sinking on soft substrate.
  6. Lay the pressure hose and fasten it in the appropriate place (e.g. drainage). CAUTION! If the pump is placed in a full chamber, hold the pump at a slight angle when immersing. This causes the air to escape from the pump!
  7. Route the connection cable to the socket/power supply.
  1. Pump is installed.